![]() ![]() Permission to the endpoints to access the resources in your network based onĮffective deployment and ongoing management of authentication by using IEEE The endpoints are profiled based on theĮndpoint profiling policies configured in Cisco ISE. Why do I need such a thing? Well, if I want to know the volume of foundation concrete (say), I find it hard reading 9 or 10 digits without any separators and trying to work out where the decimal point should be for reading in metres.Cisco Identity Services Engine (ISE) identifies the devices that connect to That would also enable you to build in the closing of the Model Info dialog box if you wanted. ![]() Ideally, hitting the designated function key would swop you back but at worst case you would have to have two separate routines with different function keys. You would also have to change the precision because you don’t generally want precision of greater than 1mm when working in mm but you do generally want at least two decimal places when working in metres. This could presumably invoke the Model Info dialog box and change the units. ![]() I believe this enables you to write a small macro that could have a function key as the instigator. On a Mac, you have the option of Services under the Sketchup menu. It’s not difficult to change the units in Model Info and back again but it would be handy to have a shortcut that toggled between the two. ![]() However, there are times when it is much better to be working in metres. Like most of the world, I work in metric and usually in mm. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |